北京pk彩票官网下载安装
Hotline:0571-64116601
Chinese | ENGLISH
PRODUCTS

LD series of high temperature stainless steel conveyor feed

  • LD large inclined angle conveyor

  • LD large angle conveyor 2

  • LD two way conveyer

  • LD horizontal conveyor 2

  • LD two way conveyor 2

  • LD horizontal conveyor 1

  • TGD head

  • TGD tail (New)

  • TGD tail roller

details

1. LD Use

1.1 horizontal conveyor is capable of simultaneously and continuously inclined conveying equipment transported. The inclination angle of 90 degrees can be achieved.

1.2 is suitable for transporting dry bulk materials 100mm diameter inside, pellets, powder, temperature is conveyed material can reach 600 ℃ ~ 700 ℃.

1.3 When pure horizontal transport, the device model is defined as SLD type; when the direct inclined conveyor, device model is defined as XLD type; when the horizontal + inclined conveyor, device model is defined as LLD type.

2.LD structure

The conveyor consists of the following components: 1, the transmission system; 2, the head unit; 3, the tail unit; 4, intermediate housing; 5, paternoster system; 6, the intermediate steering.

2.1 Transmission - Transmission by an electric motor, hydraulic coupling, reducer, coupling and coupling components. Small power conveyors, using cycloid reducer + chain transmission mode.

2.2 head unit - head unit by the head of the housing, the spindle, the head sprocket, bearing and coupling assembly and other components. XLD and LLD type is also provided with a check device to prevent a sudden power failure, etc. caused paternoster system reversed.

2.3 Tail device - the tail unit by the tailstock, tail shaft, rear sprocket, tensioner and other components. On the tail unit also has a speed detector for some reason fails (such as chain scission, fight card, etc.) can be timely feedback to the control center for disposal.

2.4 intermediate housing - intermediate casing is provided with upper and lower double track, for supporting the chain bucket system. At the same time high-temperature material enclosed housing structure to prevent drying off.

2.5 paternoster system -

2.5.1 traction chain from the chain plate, pin and sleeve and wheel components.

2.5.2 SLD type hopper and the hopper XLD mainly by pressing a shallow arc floor, wall and striker plate welded together. In order to meet the requirements of high temperature conveyor, hopper are all made of stainless steel connecting bolts are made of stainless steel products.

2.5.3 LLD type hopper mainly by press molding of pit-shaped floor, wall and striker plate welded together. In order to meet the requirements of high temperature conveyor, hopper are all made of stainless steel connecting bolts are made of stainless steel products.

2.6 intermediate steering - For LLD type conveyor, because of the need horizontal + inclined conveyor, specially designed steering a middle. This device uses pressure round form, turning the turning point of the chain will be redirected. Improved hopper structure so that the material in the horizontal and inclined stage will not reduce the amount of lifting and transporting the material does not leak, reducing the discharge head back material possible.

3.LD transmission capacity

Model

Transmission capacity m3/h

LD400

20-48

LD500

25-60

LD630

30-75

1438574062226304.jpg

北京pk彩票官网下载安装